Eliminator Stripes Application May 11, 2012 http://harrya.webs.com/apps/photos/ Eliminator Stripes Application May 11, 2012 Passenger Side May 11, 2012 .. started at 10:15 am. Applying the initial test tape line, lining it up with a laser line. http://harrya.webs.com/apps/photos/photo?photoID=155561876 155561876 Stripes being applied by Marc Scott of ForFire Enterprises. http://harrya.webs.com/apps/photos/photo?photoID=155561877 155561877 Long sections were all applied "wet" using a soapy solution to soften the glue so that once attached, it could still be adjusted a bit if necessary. http://harrya.webs.com/apps/photos/photo?photoID=155561878 155561878 Door section applied; just attaching the wrap-around ends securely. http://harrya.webs.com/apps/photos/photo?photoID=155561879 155561879 Working on the front fender section. This was a bit trickier because it narrows down quite a bit, and also needs to line up perfectly with the "extension" piece (at the very front). http://harrya.webs.com/apps/photos/photo?photoID=155561880 155561880 Smoothing it out, getting the water bubbles out. http://harrya.webs.com/apps/photos/photo?photoID=155561881 155561881 Final inspection. http://harrya.webs.com/apps/photos/photo?photoID=155561882 155561882 Applying the Eliminator decal - this was done dry so was more critical to have perfectly straight. http://harrya.webs.com/apps/photos/photo?photoID=155561883 155561883 http://harrya.webs.com/apps/photos/photo?photoID=155561884 155561884 P.S. Completed Passenger side is done .. looks great. http://harrya.webs.com/apps/photos/photo?photoID=155561885 155561885 Driver Side The initial laser tape line is on, and the Drivers door section is being applied. Interesting how much easier it was the second time we did this. http://harrya.webs.com/apps/photos/photo?photoID=155561886 155561886 Stripe is attached and being rolled out. http://harrya.webs.com/apps/photos/photo?photoID=155561887 155561887 Front fender section is ready to go on. http://harrya.webs.com/apps/photos/photo?photoID=155561888 155561888 End joints are perfectly matched (both this side and the P.S. pieces had to be trimmed very slightly (hair width) to get a perfect match. http://harrya.webs.com/apps/photos/photo?photoID=155561889 155561889 D.S. Eliminator decal is on http://harrya.webs.com/apps/photos/photo?photoID=155561890 155561890 Door to quarter panel ends match perfectly .. again!! http://harrya.webs.com/apps/photos/photo?photoID=155561891 155561891 D.S. Completed Driver side is done .. took us half as long as the P.S. http://harrya.webs.com/apps/photos/photo?photoID=155561892 155561892 http://harrya.webs.com/apps/photos/photo?photoID=155561893 155561893 Close Inspection It's straight!! http://harrya.webs.com/apps/photos/photo?photoID=155561896 155561896 Check Alignment looks perfect!!! http://harrya.webs.com/apps/photos/photo?photoID=155561898 155561898 Final Inspection http://harrya.webs.com/apps/photos/photo?photoID=155561899 155561899 Final Inspection http://harrya.webs.com/apps/photos/photo?photoID=155561900 155561900